Finally

Apply two or three layers of wax by brush to each part of your mould always ensuring the wax is almost set, again if it is too hot it will simply melt the layer below.Then clean the edges of each part of you mould and screw the mould together using butterfly bolts.

Pour melted wax into the mould through it's openings which in this case are located at the base of each leg and swirl the mould around to fix the wax parts together in side the mould.

Let the wax to set and keep in a cool place if you are in a hot country;).Then take apart the mould and the cast should come out easily from the mould.I will have to cast this again but this in micro - crystalline which is harder again and very similar to candle wax.Due to the excessive heat here the legs of the horse began to sway.